How Efficient Are Your Trenchless Pipe Replace


Pipe damage and pipe failure are extremely difficult situations to deal with if you are not a professional plumber. This is because there is no easy way to remedy such problems. Nevertheless, due to current advancements, you now have the option of trenchless technology, which may be financially beneficial.


Although some may still regard it as the new kid on the block, trenchless technology has been around for quite some time, and is enjoying increasing popularity among homeowners and business owners. This is because this option allows you to avoid digging and the subsequent need for landscape repair that typically follows.

The costliest components of conventional dig-and-replace pipe repair are not the tools or materials used, but the displacement of earth, labor, and the significant number of hours spent restoring the bad pipes. Traditional pipe repair is usually 25-30 percent costlier than trenchless alternatives. With trenchless technology, technicians use liquid epoxy-resin solutions to cure new pipe sections in place within the damaged line. This is done through tiny entry points or even pre-existing points of entry and no digging is needed.


The skills and equipment necessary for trenchless pipe repair may cost more than traditional repairs at the lower end of the price range, but this typically balances out when you reach the higher end: on average, trenchless pipe repair generally runs about $6,000-$12,000, while dig-and-replace repairs usually fall somewhere between $4,000-$16,000, with the higher end of the range accounting for manual digging. However, a lot also depends on whether or not driveways, sidewalks or utilities lie above the broken pipes. Additional labor, landscaping, and road closure also substantially contribute to the final cost of the job.


For shallow pipes with no obstructions or utilities nearby, manually digging through and replacing the pipes is typically more affordable than relining them internally via trenchless methods. On the other hand, if the pipes that were damaged are located underneath the sidewalk, beneath large trees, or under your driveway, dig-free pipe lining may put as much as $10,000 in repair costs back in your pocket.



Imagine a scenario where you go to flush you toilet and immediately realize that something has gone wrong. The water isn’t going where it’s supposed to go and, instead, you are left with a growing pool on your bathroom floor. This type of sewer and drain issue can quickly get out of control, especially if you don’t have it dealt with immediately.

Unfortunately you need a sewer repair but fortunately we have technology that is called sewer lining to help you save both time and cost. Sewer lining repair is a trenchless sewer repair and replacement all in one technique without having to excavate and tear up your property to get your side sewer lines.

Other risk factors

Another reason why pipes are cracking and breaking in the area is that we live in the Cascadia subduction zone. There is plenty of tectonic activity in this area, causing the earth to shift and potentially damaging pipes.

Any time the earth shifts, which is actually quite frequently, there is a chance that your pipes could crack or break. These pipes weren’t made to put up with a whole lot of movement and our position in the subduction zone, along with the material with which these pipes were made, has made us a high risk area.

Have Your Pipes Checked

The first thing that every homeowner should remember is that a plumber can help.


Trenchless Sewer Replacements

Non-Invasive Plumbing Solutions

When you’re dealing with a problem with your sewers, such as a back-up or a leak somewhere along the line’s route from your home to the sewer, you’re in need of professional plumbing help

You may need to replace your sewer for a variety of reasons, including:

Age. If your lines were installed a long time ago and have sustained heavy usage, they will likely require a replacement.

Frequent clogs. If you find yourself continually dealing with clogged toilets or sinks, repairing may not be the best option and a replacement may be the better choice.

Roots. It’s natural for roots in the ground to grow into your sewer lines, damaging them beyond repair.

Neglect. If you haven’t had your sewer lines maintenanced routinely, the damage they’ve sustained over time may be too much to repair and they will likely require a replacement.

How Trenchless Works

The biggest advantage of trenchless sewer replacements, obviously, is that they are far less invasive than a sewer excavation, particularly when there is a driveway or landscaping. A trenchless pipe replacement works by using a cone shaped bullet, which is pulled through the existing pipe by a hydraulic hoist. The bullet is attached to a high density plastic pipe, which gets pulled through the old pipe.

Holes are dug at both ends of the sewer line and at other connections along the sewer, the new plastic pipe is then connected to the existing connections at the city main in the street (in some cases) and at the good connection where the sewer exits the building. Clean-out fittings are installed at both ends and, after inspection, the ground and concrete or asphalt are replaced. Sewer lateral replacements do require permits and inspections.


Trenchless Pipe Repair

Pipe and sewer repairs used to be a daunting task because there are many things that need to be done in order to start the repair. Floors need to be broken and dug. Walls need to be torn down as well. Driveways and streets need to be excavated. The amount of work to be done can cost a lot!

Trenchless pipe repair eliminates all these additional charges by using a technology known as cured in place pipe (CIPP) technology. CIPP is a good option to rehabilitate damaged pipelines caused by corrosion and rust. CIPP involves creating a pipe within the old pipe using special epoxy resins. The ability to do such a thing makes it ideal when it comes to pipe repair.

Repairing pipes with excavation can cost you between 20 and 50 thousand dollars. It can even cost more depending on how deep the excavation would be plus the safety tools that would be required to use during the job.

Benefits of Trenchless Pipe Lining

Since there is no destruction of other adjacent structures, there is less interruption in your daily routine. The resin lining also prevents root intrusion and leaks. Since the lining molds into the exterior pipe, there are no gaps created where roots can possibly intrude.

It maintains the integrity of the lining and maintains a good flow capacity. The pipe is made of resin, which means it is smoother compared to concrete, cast iron or clay pipes. Due to the epoxy liner, calcium deposits will not adhere to its walls. A future blockage is prevented.

It lasts as long as 10 years or more so you do not get to replace it in less than a decade. Some trenchless pipes even last as long as 50 years. Moreover, you spend less and save as much as 40% percent compared to the usual replacement method.



Advantages of Trenchless Sewer Repair

Sewer lines are susceptible to damage caused by tree root intrusion, pipe separations, fractures caused by age, and offsets that result from earthquakes and seismic activity. Conventional methods require digging a trench along the entire length of the sewer line regardless if it reaches your yard, driveway, or landscape. Trenchless methods enable us to replace the entire length of the pipe without damaging your property, saving you time and money.

The Pipe Bursting Method

use sewer pipe bursting repair in Covina and the surrounding areas to provide a minimally invasive solution to your sewer line problem. This method involves bursting the existing pipe under the ground and pulling a new flexible fused pipe through the ground and into its place. The method works exceptionally well and provides an economical solution for your repair.

Sewer pipe bursting repair involves:

Fusing the pipes to create an exact length of the existing sewer pipe

Creating an access hole at either end of the existing pipe

Using a mechanical head with a hydraulic winch and cable to burst through the old pipe

Pulling the new pipe through the path of the existing pipe so it straightens out in the exact same position